Untitled Document

Base Plate Hints!
The Base Plate is very simple to make. Look at the image below. First, create the 200 mm red rectangle. Second, create the 25 mm green end piece and line it up with the bottom edge of the red rectangle. Third, create the 120 mm middle yellow piece and adjust it according to the measurements on the draft. Fourth, add the 25mm triangles to remove the edges of the yellow piece. Finally, add the three holes - Group - Print...you are done!

Base Plate Hints!

The Base Plate is very simple to make. Look at the image below.

First, create the 200 mm red rectangle.
Second, create the 25 mm green end piece and line it up with the bottom edge of the red rectangle.
Third, create the 120 mm middle yellow piece and adjust it according to the measurements on the draft.
Fourth, add the 25mm triangles to remove the edges of the yellow piece.
Finally, add the three holes - Group - Print...you are done!