RC_BasePlate

Base Plate Hints!
The Base Plate is very simple to make. Look at the image below. First, create the 206 mm Grey rectangle.. Second, create the 21 x 70 mm Red end piece and line it up with the bottom edge of the Grey rectangle. Third, create the 95 x 95 mm middle Yellow square and line it up according to the measurements shown on the draft. Fourth, add the 53.50 x 15mm Green rectangle and line it up with the edge of the Yellow rectangle. Finally, add the five holes (The size of all the holes are 3.18mm x 3.18mm)- Group - Print...you are done!

Base Plate Hints!

The Base Plate is very simple to make. Look at the image below.

First, create the 206 mm Grey rectangle..
Second, create the 21 x 70 mm Red end piece and line it up with the bottom edge of the Grey rectangle.
Third, create the 95 x 95 mm middle Yellow square and line it up according to the measurements shown on the draft.
Fourth, add the 53.50 x 15mm Green rectangle and line it up with the edge of the Yellow rectangle.
Finally, add the five holes (The size of all the holes are 3.18mm x 3.18mm)- Group - Print...you are done!